delete

Proper Ways to fix Wooden Shake Roofing

Fixing a wooden shake roof is actually similar to fixing shingle roofing even though it can be a bit more difficult if you are not knowledgeable and experienced enough. If you want to replace the damaged wooden shake pieces, use the same kind of shingles or shakes. Furthermore, if a ridge shingle has been damaged, consider using a new ridge shingle that is specially cut instead of replacing it with an improvised regular shingle. In this article, you will be able to learn a quick guide on how to fix wooden shake roofing.

Wooden Shake Roofing

  1. Use a sharp chisel and hammer to split the damaged shake. Slightly slant the chisel up into the shake at the same angle as roof or pitch. You should be very mindful of other surrounding shakes so make sure that you do not gouge them. After that, pull out damaged shake pieces.

Due to the fact that shake pieces are not flexible enough just like shingles, you can’t possible pry out nails. Instead, use a hacksaw to cut off the heads of the nail as far down the nail shaft as you possibly can. You might also want to wrap an electrical tape around the other end of the blade of the handsaw in order keep your fingers protected. If you cannot reach the nails without creating any damage to the other surrounding shakes, you will have to work around them as well.

  1. Measure the gap left by the old shake and cut a new one around 3/8 inches smaller compared to the original measurement, using a hacksaw with fine teeth. You must allow the 3/8 inch clearance since the shake can swell especially the first time it rains.
  2. Next, you have to install the new shake. Once you have cut off the nails that are holding the old piece of shake, simply slide the new shake piece up into the vacant place, with its upper edge under the overlapping shingles. After that, nail the piece of shake down using two galvanized roofing nails. Each nails should be placed at every side of the exposed top edge of the shake. However, if you weren’t able to completely cut off the nails that were holding the old shake; you will have to notch a new piece of shake that can fit around them.

You can then push the new shake up into the gap, pushing hard enough so that the edge will be marked by old nails. After that, cut the slots at marked points carefully using a coping saw. Whenever possible, clam the shake in a vise so that it will not split. Slide the notched shake piece into place and then nail it using two galvanized roofing nails.

  1. Set nail heads using a nail set and then seal them with the right caulking compound. Roof leaks usually occur at flashing joints like vent pipes are around chimneys, as well as at open roof valleys.

Always remember that if this guide doesn’t work well of if your roof is still leaking after you have followed the steps listed in this article, it only means that you will have to hire professional roofing contractors in Nashville TN to have your wooden shake roofing repaired.